Traverse City is great place.
Check out Traverse City guitar on Front Street - good people, nice atmosphere, even some cool guitars by local luthiers.
The Sleeping Bear Dunes are a must see and it's only 30-45 minutes.
Must have a burger and a beer at Art's Tavern in Glen Arbor - couple miles...
Q: How do you get an electric guitar player to turn down his amp?
A: Put charts in front of him.
Sorry, couldn't resist, the last time I played from charts back in September, my amp was on 1-2
Bob
Veatch:
You are correct, the control cavity is very similar to yours.
I haven't disconnected the jack yet, but my open end Craftsman 9/16" doesn't fit in there very well.
I guess my new question is, aside from the tool in Cynic's post, is there a tool to grab the knurled outside edge of...
Veatch:
I will double check and post photo tonight.
As I recall, only the terminals of the jack were exposed - the rest of the jack was inside the body, the nut was not exposed.
Thanks for the photo.
Bob
Hey Guys:
I know this topic has been addressed a couple of times - I searched barrel jacks.
I need to replace a Switchcraft long reach jack in my Artist Custom.
From the pictures, it looks like there's a fine knurled edge on the outside and a hex nut on the inside.
How do you get into the...
No affiliation
Though it's near me - I was thinking $750.........tops.
http://www.gomusicman.com/shop/item.aspx?itemid=1662
Or have Hamers finally doubled in value?
Your thoughts?
Weber offers a 5F6-A Head kit for $545
Most transformers are equipped wsith 2,4,8 ohm output leads, but you have to know which is which. (usually color coded)
Buy the head, wire it up with 4 and and 8 ohm output jacks and you are in business.
Definitely not for the first time builder (and...
Happy Birthday Kim:
Were you happy when UM went down against Kentucky?
Thanks again for your help.
Check went out to the puppies and kittens last week.
Bob
I know this has come up before but I can't find the thread.
Who has Hamer volume pots?
Just bought a used Monaco Elite GT. The good news - it's loaded with Fralin P90s; the bad news is it's a DIY job that boogered the volume pot for the bridge pickup.
Thanks for the help.
Bob
I have a 95 Studio with a fixed bridge and one adjustable section with a hex screw.
It appears the hex head is stripped - anyone know what size the screw is or where I can get a replacement?
Thanks,
Bob
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.