Hey Guys:
I know this topic has been addressed a couple of times - I searched barrel jacks.
I need to replace a Switchcraft long reach jack in my Artist Custom.
From the pictures, it looks like there's a fine knurled edge on the outside and a hex nut on the inside.
How do you get into the jack cavity to grab that hex nut?
I've checked Stewmac for tools, done Internet searches, checked Youtube - the whole 9 yards but I can't figure out how to get the old jack OUT much less get a new jack IN.
Please share your secrets.
Thanks,
Bob
I know this topic has been addressed a couple of times - I searched barrel jacks.
I need to replace a Switchcraft long reach jack in my Artist Custom.
From the pictures, it looks like there's a fine knurled edge on the outside and a hex nut on the inside.
How do you get into the jack cavity to grab that hex nut?
I've checked Stewmac for tools, done Internet searches, checked Youtube - the whole 9 yards but I can't figure out how to get the old jack OUT much less get a new jack IN.
Please share your secrets.
Thanks,
Bob

