Steve Stevens Restoration help

charv712

New member
Hey everybody, I am going to begin restoration efforts on this early SS and I was hoping to get some information/help. Does anybody know where I can get a Hamer Steve Stevens decal? The one with the Signature script and Hamer Logo. Are water slides the best decal option? Or is there another way to go about that? Anyway, I’m thinking of painting it a solid color. I am planning to spray primer on the body/neck/headstock to give me a nice foundation to sand flat. Any suggestions or help as I get started on this would be appreciated. Thank you

4542DC15-CAEF-4012-B5A0-C1D56E65A520.jpeg

F39D5215-3F5C-472E-91B2-37F353068A7C.jpeg

80E2A14E-45E3-4D7B-8184-61CE851C312A.jpeg

E9B7DD6B-5233-4BDA-93BD-3407B8C5830E.jpeg

E806B336-355E-4033-80DA-6AAFA8CE34B1.jpeg

9518B9CB-241D-4749-8D8B-6389DAD8B26B.jpeg

 
Whatever you do, DO NOT USE WATERSLIDES!!

Use the opaque dry transfers or it will look like crap.

There are a few places that have made the correct logos for that era as well as the Steve Stevens sig for the front - I think ALLOut Graphics (in Canada, but they ship everywhere) has done those before.

https://www.allout-graphics.com/pinwall/

 
Last edited by a moderator:
Thank you very much for the tip. I’m not familiar with opaque dry transfers. How are they applied? And can I spray clear over it? Thanks again for your help 

 
They are the same technology as Letraset if I recall correctly, position over where you want them and rub the plastic sheet they come on with a burnisher or similar, and hey presto.

Then clear coat over the top.

Hope that helps!
Ben.

 
Can someone here on the forum please help me to get a high resolution/clear picture from straight on, of the Steve Stevens headstock logo? I was told by the people making the logo that a “vector file or scan would be best” but a photo at 90 degrees would also work. Is there anyone around who can help me with this? What is a vector file? Thank you everyone for your help!

 
Gorgeous mahogany grain on the back!

Free advice/Suggestion: Plug up (dowels and glue) those 'through the neck (peghead)' Floyd Rose locking nut anchor holes and install a locking nut that attaches from the fingerboard side. That original design is a broken headstock waiting to happen. Good Luck!

 
Here you go, see if this helps as a starter for 10... ignore dust...

50144707217_4337770f93_o.jpg%20


 
Last edited by a moderator:
Thank you very much Benny Boy! Could you also get me a picture of the other end, with the USA portion...? I really appreciate this. Maybe even a nice close up of the complete Decal, Signature to USA. Thanks again!

 
Mods: back when I first joined the HFC ('08 IIRC) there was an HFCer who documented just this very project. 

The SS was black and my memory it was in much worse condition when started than this guitar. 

I'm looking for it, but maybe the moderation tools provide for a faster search?

ETA: I think I may have found it!  Lots of missing / obscured photos due to the Photobucket effect, but maybe this will help.




 
Last edited by a moderator:
Back
Top