12 string bass

Tommy

New member
I've been looking for an American made Hamer 12 string bass for a long time. Anyone with a one or a lead to one would be greatly appreciated. Thanks.

 
Timing! I had one posted here for a bit, but just sold it about 2 weeks back. Good luck with the search!

 
Yeah, that's right. I'm looking mainly for a Hamer Chaparral or B12, 34 inch scale. Thanks for asking and I hope you might be able to help me. (:

 
Thanks for the heads up. I offered them $2500. It sold in three hours for the asking price of $2750 I think. I learned my lesson, don't go cheap. Next time I'll just pay the price and get it. I'm getting frustrated trying to get one of these.

 
I'm looking for a stock one with two pickups and one output jack. Thanks for the pic, it's a great looking bass.

 
It is awesome, just not practical for my setup. I use one amp and I don't like the three output thing. Too limited with what I can do with the pickups. Stock ones are always cheaper.

 
If you've never played one.....

It is very hard to amp a 12ver right using one amp. Most guys split the hi/low signal because the wall of frequencies produced by a 12ver is fairly complex. Works much better with the lows to one amp and the highs to a separate amp with some overdrive.

That is why you see the 12vers with two or three outputs....more control running the neck PUP to an amp and the bridge PUP(s) to the other amp. If you have a single output, you will be running that full range signal to a splitter box and then to two amps.

 
Last edited by a moderator:
You talking about the rig he used for years or his new 1000 watt signature amp....which is basically two amps in one -- a bass channel for a solid low end and a distortion channel for the hghs.....just like I said you need to,do.

Here's his old rig. Again, multiple amps and crossovers and overdrives to split the 12ver sgnal into lows and overdriven hghs, like I said.

View attachment 11432

 
Ok, you are the master and I'm just an idiot. I just can't afford more than one amp, at least for a while. I'll be putting all my money in the bass and I can barely afford that.  

 
Dude.....just trying to school you in 12ver, so you can make the right decision on what you are trying to do.

A lot of guys buy them, use them wrong and then sell them because they can't make them sound like they want them to.

You can use a cheap guitar combo with overdrive and a splitter pedal for the high end...and your existing bass rig for the lows. Doen't need to cost much.

BTW....if ypu happen to be a great singer Dug is looking for one for his new project with Stewart Copeland.

 
With my B12s, I use a dual amp chain programmed into the Axe FX using EQ blocks as crossovers. The high freqs are fed into a marshall model and low freqs into a orange bass model. There is a crossover block that could be used instead I've never really played with it.  You can do the same thing on the kemper profiler using the dual path feature but the bass signal (including the treble freqs) would be 100% direct with no processing. If my bass had split outputs that would be ideal.

 
Last edited by a moderator:
Back
Top